What is ESW Cisco?

ESW stands for Essential Service Operate and UCSS stands for Unified Communications Software Subscription. These were two different services: with ESW , customer was entitled for minor upgrades and TAC assistance.

How do I access the switch module on a Cisco router?

Press < Ctrl+Shift+6 >, then press x . This sequence returns you to the router console while keeping the console session to the switch module intact and then exits the console session to the switch module.

What is nm module?

The Network Analysis Module (NM-NAM) feature is a network module that monitors and analyzes network traffic for a system using extended Remote Monitoring (RMON) standards, RMON2, and other Management Information Bases (MIBs).

What is switch module?

The Gigabit Ethernet port GE0/1 on the switch module consists of a pair of one RJ-45 connector (topmost port) and one SFP module connector (bottom port). The two connectors are not redundant interfaces—the switch module activates only one connector of the pair at a time.

How do I access a Cisco core switch?

How to configure Cisco switch?

1. Initial command prompt “Switch>” appears on the screen.
2. Type “enable” next to it and press “Enter”.
3. This will take you into the “EXEC” mode, also known as the Global Configuration mode.
4. Go into configure mode using configure terminal.
5. Enter the configuration commands one per line.

How many modules are there in CCNA?

four modules
Exams and Progression Routes You can prepare to take the Cisco CCENT certification exam after completing the first two modules and/or the CCNA Routing and Switching exam after completing all four modules.

What is module in router?

A router module is a critical component of any network infrastructure, especially for companies with multiple control hubs or internal networks. Computer router modules do the extremely difficult chore of routing traffic like a traffic light through the best pathways.

How to configure Cisco EtherSwitch network module ( ESW )?

Refer to Cisco EtherSwitch Network Modules – Data Sheet for more information on ESW modules. Refer to Cisco EtherSwitch Network Modules Feature Guide to understand how to configure ESW modules. ES modules have their own processors, switching engines and Flash memory that run independent of the host router resources.

Which is the default QoS configuration on ESW?

The access port configuration is similar to the standard LAN switch configuration. The voice port configuration is similar to the standard LAN switch configuration. This is the default QoS configuration on the ESW module: These sections explain these configurations: You cannot configure port-based QoS on the Layer 2 switch ports.

How does the ES module in a router work?

ES modules have their own processors, switching engines and Flash memory that run independent of the host router resources. After the ES module is installed in the router, you can console into the ES module from the host router. Then you can create VLANs, configure VLANs, spanning tree, VTP, and so forth from the ES module.

What kind of router does Cisco EtherSwitch use?

If your network is live, make sure that you understand the potential impact of any command. This configuration can also be used with these hardware and software versions: Cisco 2600/3600/3700/3800 Series Routers. Refer to Table 4 in Cisco EtherSwitch Network Modules – Data Sheet.