Where are the trouble codes on a Subaru?
Where are the trouble codes on a Subaru?
There are self-diagnositic connectors on all models, when connected with the key ON (engine off), flash trouble codes on the LED light of the oxygen moniter of the ECU. Images used with permission Copyright © 2001 ALLDATA LLC.
What are the OBD codes for a 1983 Subaru?
This should clear the codes. Vacuum switches stay on or off (1983 only)/Duty solenoid or circuit (1983 to 1985)/Injectors 1 & 2 (87-up) Ignition pulse system (1983 only)/Vehicle speed sensor or circuit or VLC solenoid valve or circuit. (1984 to 1988 carbureted)
How do you reset the Check Engine light on a Subaru Outback?
Then try to slide the cable off the negative battery terminal. You now have to wait 4 to 5 minutes, before your then reconnect the cable and tighten the retaining nut. Finally, start the car engine and wait for the vehicle Subaru’s computer to reset the check engine light.
Is there an OBD code for a Subaru imprenza legacy?
95 Imprenza and Legacy models have OBD2 systems and require a scanner,but some basic codes can be retreived using the flashing MIL method. Codes will only clear when the faulty system or circuit has been repaired.
What kind of engine does Subaru ex13d have?
The EX13D has cast iron cylinder sleeve, ball bearing supported forged steel crankshaft, improved piston design. The piston has two compression rings and one oil ring. ATTENTION!
Where are the codes on a Subaru SVX?
On SVX models the connectors are located behind the driver’s side kick panel. With neither test connector connected and the key ON (not running), the codes will display codes related to starting and driving. With only the “Read Memory” connector connected, historic codes will be displayed.
What kind of engine does a Subaru Robin have?
The Subaru-Robin EX13D is a 126 cc (7.69 cu-in) single-cylinder air-cooled 4-stroke internal combustion small gasoline engine manufactured by Industrial Products division of Subaru Corporation for general-purpose applications.