What to do after you install a new fuel pump?

After replacing a fuel pump and fuel filter, it is highly recommended to fuel up at a gas station with good gas, such as Techron or Chevron. This fuel is very clean and has detergents that help clean the fuel system.

How long does it take for a new fuel pump to work?

We found that the average fuel pump replacement job can take anywhere between 1 and 6 hours. Engines vary between different car makes and models, as does the time this repair takes. This variation can be due to the construction of the vehicle.

How do you reset the fuel gauge on a Chevy Silverado?

To reset the fuel gauge on the 2006 Chevy silverado you need to hit the odo/trip button, then turn the vehicle off. Hold the button and turn it back on and make sure it says it is in odo/trip mode. Now turn the vehicel off again. Wait 10 min, turn it on, then turn it off.

Why is my gas gauge not working after fuel pump replacement?

When you were installing the fuel pump module back into the fuel tank you may have inadvertently bent or damaged the the fuel gauge sending unit. If the sending unit arm got bent when installing it then it will bind up on the metal anti slosh plates inside the fuel tank.

Is changing a fuel pump easy?

Replacing your fuel pump isn’t as hard as you might imagine. In most, you must drop the fuel tank, and first drain most gas if needed. Some vehicles have an access panel in the body to get to the top of the tank to remove the assembly without dropping the tank.

Why is my gas gauge reading wrong?

The most common problem that causes the fuel gauge to read incorrectly is a bad fuel sending unit. This ensures that the driver is aware of the fuel level at all times, as well as warn when the vehicle is low on fuel, and when to visit a gas station before the tank is completely empty.

How do I reset my fuel gauge needle?

How to Reset a Fuel Gauge

1. Turn the ignition switch to the “On” position.
2. Press the “Odo/Trip” button until the odometer is put into “ODO” mode.
3. Turn off the ignition.
4. Press and hold the “Odo/Trip” button.
5. Release the “Odo/Trip” button.

When to replace the fuel pump on a Chevy Silverado?

If your Chevrolet Silverado isn’t performing the way it once did, or if you feel like you’re stepping on the gas pedal and not much is happening, it may be time to replace the fuel pump. This article applies to the Chevrolet Silverado (1999-2006).

How do you Drop the fuel tank on a Chevy Silverado?

This article will walk you through the second method of dropping the fuel tank. Open the hood. Pull the fuel pump relay from the fuse box. Start the vehicle and let it run until it shuts down. Figure 1. Pull the fuel pump relay and start the engine in order to relieve gas pressure in the line and the pump.

What to do if your fuel pump wont start?

ONE WAS A BIGGER WIRE GAUGE WHICH YOU CAN TELL BY CAUSE ONE WAS THIINER THAN THE OTHER AND I HAD ONE GRAY AND ONE PURPLE SO HERE THE THE PROPLEM THAT I CAME ACROSS WELL THE NEW FUEL PUMP CAME WITH THE NEW HARNESS AND A DIRECTIONS HOW TO RECONNECT THE WIRES BY THE COLOR CODE I DID EXACTLY WHAT IT SAID AND DIDNT START !!!!!

Can a Silverado truck start after fueling up?

After filling up the truck she I went to start it up it wouldn’t. Acted like it was starting. All the dash lights came on. After a few mins/tries it started. Has happened 3 straight times now. Every time after it has started fine. Here is a video.