Helpful tips

How do I program duress code on DSC 1832?

by Minnie

How do I program duress code on DSC 1832?

Once the code has been added, follow the steps below to assign the Duress attribute.

  1. Enter attribute programming. At the DSC Impassa, enter the command [*] + [5] + [Master Code] + [9].
  2. Assign the attribute. Once the correct user is displayed, press [*].
  3. Exit user programming.

How do I bypass DSC 1832?

With an LCD Keypad:

  1. The System Must be disarmed prior to proceeding.
  2. Press the * Key.
  3. Press the 1 Key.
  4. Use the > key to scroll to the zone you wish to bypass.
  5. Press the * Key on the appropriate zone.
  6. A “B” should appear next to the zone when the system is bypassed.

How do you program a DSC zone?

To program your zone definitions, you must:

  1. Enter Programming by pressing ” * 8 + Installer Code “
  2. Enter Section 001 (Section 001 is used for Zones 1 – 16 only…
  3. Now you will enter Zone 1’s 2-digit definition.
  4. The system will triple beep, and now you will enter zone 2’s definition.

How do I program a DSC?

To default the system you will enter into programming mode by typing:

  1. *8 5555 on the keypad.
  2. You will then be asked for ‘Section’ .. Enter in 999.
  3. You will then be asked to enter Installer code .. Enter 5555.
  4. The keypad should beep and then ask you for ‘Section’ again .. Enter 999 again.

How do I program a DSC code?

How to add or remove a user code on a DSC Power Series security alarm panel

  1. Press the * button followed by 5.
  2. Enter your system’s master code (If you do not know your system’s master code, contact Bulwark)
  3. The “Armed” light will illuminate on the keypad, and the “program” or “System Indicator” light will begin to flash.

How to program DSC power series 1616, 1832 and 1864 alarm system?

Hi, Ryan here with alarmsystemstore.com to show you on how to program your DSC PowerSeries 1616, 1832 or 1864 alarm system. So let’s get right to it, let’s go to my table and let’s program the system. Now, you’ve got your system all wired up, and it’s ready to be programmed.

How to program a DSc power series system?

Below we’ll show you how to program a DSC Power Series system. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Is there a quick start guide for 1832?

For the systems we sell we do have a quick start guide, and it basically dissects the installation manual. For the 1832 since the new version 4.6 came in our quick start guide kind of got expanded a little bit to about five or six pages just for the simple fact that quick start guide cover’s version was 4.5 and older, and 4.6 and newer.

When to use a DSc power motion detector?

It’s typically used for motion detectors when your system is armed in away mode, your motion detector will be armed, it will go off instantly. If your home and your system is armed in the stay mode, your motion detector will be bypassed.